PHENIX Technologies HC Series Circuit Breaker Test Sets represent a new era of economical and portable primary injection testing through the following industry leading innovations:
- Versatility of either manual control through the User Interface Panel or remote control interface through WinHC PC software both allowing numerous automated test modes.
- Increase your test reliability and productivity. WinHC PC software provides advanced database and report capabilities for test duplication and recall, report generation and current wave shape display.
- Designs based on time-proven concepts of the power offered by a 32-bit embedded computer.
- High reliability SCR's have been combined with a phase angle firing system to deliver precise, repeatable current pulses with minimal distortion.
- Wide ranging test versatility and exceptional accuracy through automated hardware combined with a highly intelligent monitor/controller.
- Continuously variable output over entire test range utilizing a motorized vernier and programmable tap selector allowing for both auto-jog and current-hold capabilities.
Application
- These test sets are universal in application. They will test virtually any low voltage, molded case, or metal clad direct acting AC circuit breaker by simulating overload and fault conditions.
- Maximum testing capability up to 7,500 amp breakers.
- Other applications include testing current transformers and thermal or magnetic motor overload relays.
- Configured in a series, they can be used for substation maintenance for primary injection testing on high voltage circuit breakers and protective relays.
Outstanding Features
- Normal – In this mode the operator manually controls the operation of the test set.
- Jog-To-Hold – In this mode the test set jogs the output on at "Jog On Cycles" and off for "Jog Off Secs" and raises the output until the "Hold Amps" is reached.
- Jog-to-Trip – In this mode the test set jogs the output on at "Jog On Cycles" and off for "Jog Off Secs" until the circuit breaker under test trips.
- Current Hold – In this mode the output is held within 1% of the "Hold Amps."
- Memory – This mode is used for testing the sensitivity pickup of electronic controllers. (When the Stop button is pressed the current level is remembered).
Download our brochure for full information on the specifications and features of this product.
High Voltage - High Current - High Power
PHENIX TECHNOLOGIES IS LEADING THE WAY
 USER INTERFACE THIMBNAIL.jpg)
